Ganz ZC-PT336N-IR User manual - page 18
B-7-2. DOME SET - [NEXT PAGE] -SYSTEM LOCK
All stored dome settings can be password protected to prevent unauthorized changes. In order to
enter [PASSWORD] page, the system lock status must firstly be set as ON. The default setting is
OFF.
B-7-3. DOME SET - [NEXT PAGE] -[PASSWORD].
To enter this page to set a password. move joystick or pan key in the right direction.
The password must be set by preset number from 001 to 255 (Default 99).
OSD Menu Setting
Enter any number from 001˜255 on the password blank area and again on the confirm blank area.
Then “CONFIRMED” is displayed on the monitor and the menu will go back to the previous
age automatically.
If you press an incorrect number between PASSWORD and CONFIRMED,
“
CANCELLED” is displayed on the monitor when you press FOCUS NEAR key.
“
CANCELLED” will be displayed on the monitor, it goes to previous page.
•
When a password has been set, the operator must enter the correct password in order to enter
OSD MAIN MENU, or to change any of the domes configuration data.
•
If you set a password you must ensure that it does not get lost. If this happens the dome must
be returned for workshop repair.