Ganz ZC-PT336N-IR User manual - page 23
Use the joystick or pan left / right keys to select the number.
D-2. PRESET - PRESET ID
To create preset titles use the joystick or pan left / light keys to navigate the menu.
The ZOOM TELE button moves to the next character from left to right and ZOOM WIDE button
moves to the next character from right to left. (Space displays when □ appears.)
D-3. PRESET - PAN : XXX.X TILT : XX.X
Preset FOCUS FAR button in order to set preset position then, use the joystick or pan left / right
keys to the position where memorized preset number is needed.
Then press FOCUS FAR button again after setting a preset location.
D-4. FREEZE MODE : On Preset, you make a decision whether you get it move or stop.
On ON, Freeze Preset can be working on.
D-5. FREEZE ALL : You can set it up into ON / OFF, on ON, Freeze all should be working on.
D-6. PRESET - SAVE
Move the joystick right or press the pan right key when the cursor is at SAVE and then the cursor
will be located on Preset ID for the continuous preset No. setting.
D-7. PRESET ‒ EXIT
To escape this page, move joystick to the right direction.
OSD Menu Setting
E. Auto Scan Set
66+Preset button is working as AUTO SCAN after setting.
E-1. AUTO SCAN - START ANGLE.
To set the start position, press FOCUS FAR button then move the dome to the required start
position. Press FOCUS FAR button again is to escape.
E-2. AUTO SCAN - END ANGLE
To set the end position, press FOCUS FAR button then move the dome to the required end
position. Press FOCUS FAR button again is to escape.
E-3. AUTO SCAN - DIRECTION
Auto Scan directions are available as CW or CCW.
•
CW : Clock wise direction. [Default]
•
CCW : Count Clock Wise Direction.