Gardenline GLPT 2538 User Manual - page 12
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
23
25cc Petrol Grass Trimmer – GLPT 2538
Safety
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
22
25cc Petrol Grass Trimmer – GLPT 2538
Safety
– You must replace a worn or damaged spool. Pull off the
spark plug boot and remove the spark plug before
doing so.
– Damaged switches must be replaced by a customer service
workshop. Do not use any tools if the power switch cannot
be turned on and off.
– Defects in the machine, including defects affecting
protective devices and the spool and line, must be
reported to the person responsible for safety as soon
as they are identified.
– For your own safety, only use accessories and auxiliary
equipment specified in the instruction manual or
recommended or specified by the tool manufacturer.
Using tools or accessories other than those recommended
in the instruction manual or catalogue may put you at risk
of personal injury.
– The following factors may influence the effect of noise on
the operator:
– Over-extended use for long periods of time. Take regular
breaks with the machine switched off.
WARNING!
Risks associated with using the grass trimmer
If used improperly or in a negligent manner, the grass
trimmer can inflict serious injury!
– Carefully read through the instructions on proper
handling, preparatory steps, maintenance, starting and
switching off the grass trimmer. Familiarise yourself with
all controls and switches as well as proper use of the grass
trimmer.
– The rotating spool and cutting line poses a risk of injury
for other persons, animals and your hands and fingers.
Pay attention to the direction of rotation of the spool and
cutting line.
– Set up the grass trimmer in a stable position.
– Prevent accidental start-up. Pull off the spark plug
boot and remove the spark plug before you make any
adjustments to the device, or make changes to the
line spool.
– Safety devices on the machine may not be removed or
dismantled.
– Check to make sure that moving parts are functional, that
they are not jammed and that the parts are not damaged.
All parts must be properly fitted to guarantee the safety of
the device.
– Damaged protective devices and parts must be
professionally repaired or replaced by a customer service
workshop to the extent not otherwise specified in the
instruction manuals.