Gardenline GLPT 2538 User Manual - page 15
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
29
25cc Petrol Grass Trimmer – GLPT 2538
Set up
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
28
25cc Petrol Grass Trimmer – GLPT 2538
Set up
2. Fitting the long handle (Fig. 4a-4b)
No tools are required for this part of the assembly. Remove the transport guard cap
from the lower long handle. Undo the handle screw (Fig. 4a/Item 21) on the connecting
piece of the upper long handle (1). Carefully slide the lower long handle (Fig. 4a/Item C)
into the connecting piece on the upper long handle. When doing so, take care to ensure
that the drive shafts on the insides of the long handles slide into each other (turn the
spool head gently, if required) and that the spring lock (Fig. 4a/Item 2) on the lower long
handle latches securely in the connecting piece (Fig. 4b/Item D). Now retighten
the handle screw (21). To dismantle, proceed in reverse order.
Fig. 4b
1
D
21
Fig. 4a
1
C
2
21
Fit the spool assembly (13) to the bottom of the drive shaft, aligning the hexagonal hole
in the spool to the shaft (Fig. 5c), and then add the retaining screw (Fig. 6a/Item G) and
tighten clockwise. Use the key (10) to fully tighten the retaining screw (Fig. 5d).
3. Fitting the guard hood
WARNING!
The guard hood (14) must be fitted at all times.
Attach the guard hood (14) to the lower long handle (Fig. 5a). Screw the guard hood
tightly in position with the screw set (16) (Fig. 5b). Locate the screw through the guard
hood and bracket on the lower shaft and tighten the locking nut with the supplied
8/10 mm open ended spanner.
Fig.5a
14
Fig.5b
16
16
Fig.5c
Fig.6a
G
Fig.5d