Gardenline GLPT 2538 User Manual - page 17
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
33
25cc Petrol Grass Trimmer – GLPT 2538
Use
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
32
25cc Petrol Grass Trimmer – GLPT 2538
Use
Use
Description of the components and control elements
Fig. 1b
5
7
4
Fig. 1c
9
12
11
Functional description
Proper use
The Petrol Grass Trimmer is to be used only for its prescribed purpose. Any other use is
deemed to be a case of misuse. The user/operator and not the manufacturer will be liable
for any damage or injuries of any kind caused as a result of this.
Please note that our equipment has not been designed for use in commercial, trade or
industrial applications. Our warranty will be voided if the machine is used in commercial,
trade or industrial businesses or for equivalent purposes.
4
Starter line / starter cable.
5
Choke lever.
7
Fuel pump “primer”.
9
ON/OFF switch.
11
Throttle lever.
12
Throttle lock.
Operation
Please note that the statutory regulations governing noise abatement may differ from
one location to another.
Each time before use, check the following:
– That there are no leaks in the fuel system.
– That the equipment is in perfect condition and that
the safety devices and cutting devices are complete.
– That all screws are securely fastened.
– That all moving parts move smoothly.
Starting the engine when cold (See Fig. 1b - Fig. 1c)
Fill the tank with the oil/petrol mix. See also 'Fuel and oil' on page 31.
1. Set the equipment down on a hard, level surface.
2. Press the fuel pump (primer) (Fig. 1b/Item 7) 10 times.
3. Move the On/Off switch (Fig. 1c/Item 9) to 'I'.
4. Set the choke lever (Fig. 1b/Item 5) to ' '.
5. Hold the equipment firmly and pull out the starter cable (Fig. 1b/Item 4) until you
feel it begin to resist. Then tug sharply on the starter cable 4 times. The equipment
should start.
6. Once the engine has started, allow the equipment to warm up for 10 seconds.
CAUTION!
Never allow the starter line to snap back when it has been
pulled out. This may result in damage.
CAUTION!
Since the choke (5) is closed, the cutting tool starts to operate
immediately the engine is started.
7. Then release the choke (5) by actuating it once. Actuating the throttle lever will also
release the choke lever. (The engine returns to its idle state). If the engine does not
start up, repeat steps 5-6 above.