Garmin GNC 420AW Installation Manual - page 51
400W Series Installation Manual
Page 3-7
190-00356-02
Rev. F
Table 3-4. Pin Contact Part Numbers
78-pin conn
(P4001)
44-pin
conn
(P4006)
25-pin Connector (P4002)
Shield Ground
Connector
Connector
Type
High Density Pin
Contact
Standard Density Socket Contact
.1-inch Pitch Card-Edge
Wire Gauge
22-24 AWG
18 AWG
20-24 AWG
20-24 AWG
Garmin P/N
336-00021-00
336-00023-00
336-00022-00
336-00029-00
Military P/N
M39029/58-360
N/A
M39029/63-368
N/A
AMP 204370-2 N/A
205090-1 583853-4
Positronic M39029/58-360 FC6018D
M39029/63-368
N/A
ITT Cannon
030-2042-000
See Note 2
031-1007-042
N/A
NOTES
1.
Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject
to change without notice.
2.
Alternate contacts for 18 AWG wire: As an alternative to the Positronic contacts listed (and
provided in the installation kit), the installer may use contacts made by ITT Cannon under P/N
031-1007-001. These contacts require the use of a different crimp tool positioner than shown
in the table, with the part numbers as follows: Daniels P/N K250, Astro P/N 616245, or ITT
Cannon P/N 980-0005-722.
3.
For the card-edge connector pin contacts, use AMP part number 90272-1 or equivalent
crimping tool.
To prevent a possible short across the pins in the wiring harness, Teflon shrink tubing P/N 312-00005-05,
provided in Connector Kit 011-00351-00 (P4002) covers the oversized power and ground pin contacts
P/N 336-00023-00 (pins 11, 12, 21, 22) that protrude from the back of the connector shell. Before
crimping the pins onto the wire:
1.
Cut the tubing (312-00005-05) into 4 equal lengths.
2.
Slide a short piece of the tubing over the wire.
3.
Strip the wire and crimp the pin (336-00023-00) onto the wire.
4.
Insert the pin into the connector shell.
5.
Slide the tubing over the exposed portion of the pin and shrink using a heat gun.