Garmin GNC 420AW Installation Manual - page 97
400W Series Installation Manual
Page 5-17
190-00356-02
Rev. F
5.3.13
166B
VOR DISCRETE INPUTS Page (GNS 430W
Only)
Select the VOR DISCRETE INPUTS Page (see
435H
Figure 5-16).
This page allows you to verify the operation of an external
VLOC transfer switch that may be present in the installation.
Selection Verify
That:
REMOTE XFR
The box is filled in while a remote VLOC transfer switch is pressed.
5.3.14
167B
VOR/LOC/GS CDI Page (GNS 430W Only)
Select the VOR/LOC/GS CDI Page (see
436H
Figure 5-17).
This page allows you to verify and calibrate the CDI outputs,
both lateral (LAT) and vertical (VERT) from the
VOR/LOC/Glideslope receiver, as well as the OBS resolver input
to the VOR receiver. It also allows you to select the format for
DME tuning data. Using the controls on the GNS 430W front
panel, make the selections below and verify the interfaces as
appropriate:
NOTE
The LAT, VERT, and SELECTED COURSE configurations only apply to installations
where a CDI/HSI is connected to the VOR/LOC/GLIDESLOPE pins on connector
P4006.
CDI (LAT/VERT)
Selection Verify
That:
Max left
The CDI is “pegged” to the left/up.
Full left
The CDI is deflected full scale to the left/up.
Std. left
The CDI is deflected left of center.
Center
The CDI is centered.
Std. right
The CDI is deflected right of center.
Full right
The CDI is deflected full scale to the right/down.
Max right
The CDI is “pegged” to the right/down.
FLAG (LAT/VERT)
Selection Verify
That:
Hide
The LAT/VERT flag is hidden.
View
The LAT/VERT flag is in view.
S-FLG (LAT/VERT)
Selection Verify
That:
Hide
The LAT/VERT superflag is hidden.
View
The LAT/VERT superflag is in view.
Figure 5-16. VOR DISCRETE
INPUTS Page
Figure 5-17. VOR/LOC/GS CDI Page