Garmin GTN 6 series Maintenance Manual - page 20
GTN 6XX/7XX Part 27 AML STC Maintenance Manual
190-01007-B1
Page 3-2
Rev. 1
3.2 Software Loading
3.2.1
GTN Software Loader Card Creation
A GTN Software Loader Card may be created using GTN Downloadable Software and an SD card in
conjunction with a GTN software application downloaded from the Dealer Resource Center on Garmin’s
website. The Dealer Resource Center will allow the technician to choose which software package(s) to
load onto the card.
NOTE
The downloadable application to create the GTN Software Loader Card only runs on PCs
with Windows. Windows 2000, XP, Vista, and Windows 7 are supported. There is no
Macintosh support at this time.
NOTE
An SD card reader is needed to create the GTN Software Loader card using the
application that is downloaded from Garmin. The approved readers are SanDisk®
SDDR-999 and SDDR-93, although other SD card readers will work.
Create a GTN Software Loader Card as follows:
1. Go to the Garmin
Dealer Resource Center
.
2. Download the GTN Software Loader Image.
Refer to the Equipment List
(P/N 005-00533-H1) for the correct Software
Loader Image part number.
3. Ensure that you have an SD card reader
connected to the PC. Insert the SD Card into
the card reader.
4. Run the executable file. The screen shown in
Figure 3-3 will appear.
5. Click Setup. The window shown in
Figure 3-4 will appear to guide you through
the software loader card creation process.
Figure 3-3. GTN Software Updater
Figure 3-4. System and Software Version