Garmin GTN 6 series Maintenance Manual - page 76
GTN 6XX/7XX Part 27 AML STC Maintenance Manual
190-01007-B1
Page 6-12
Rev. 1
6.3.7
Traffic or Weather System
Perform the appropriate interface check for the traffic or weather system. No additional GTN configuration
steps are required for replacing a traffic or weather device with an equivalent unit.
6.3.7.1
Ryan TCAD Traffic System Interface Check
If a Ryan TCAD has been connected to the GTN 6XX/7XX unit, the traffic interface should be verified as
described in this section.
1. Go to the Traffic page on the GTN from the HOME page group.
2. Verify that NO DATA is not displayed in yellow on the center of the traffic page.
3. Using the SHIELD SETUP under the Traffic Menu, verify that the shield mode can be changed.
6.3.7.2
ARINC 429 Traffic System Interface Check
If a Garmin GTS 8XX Traffic system, L-3 Communications SKY497/SKY899 SkyWatch® sensor or a
Honeywell (Bendix/King) KTA 810 TAS/KMH 820 IHAS has been connected to the GTN via ARINC
429, the traffic interface should be verified as described in this section.
1. Go to the Traffic page on the GTN from the home page.
2. Verify that NO DATA is not displayed in yellow on the center of the traffic page.
3. If the GTN is configured to control the traffic system. Verify that the traffic system mode can be
changed from STBY to OPER.
4. Switch the traffic system mode to STBY, and then run the traffic self test from the Menu.
5. Verify that the traffic system executes a self test and that a self-test pattern is displayed on the GTN
traffic display.
6. Restart the GTN in Configuration Mode.
7. On the Traffic page in the External Systems page group, verify that there is data displayed in the
Altitude field.
6.3.7.3
TIS (Garmin GTX 33/330) Interface Check
If a Garmin GTX 33/330 transponder has been connected to the GTN as a TIS traffic source, the traffic
interface should be verified as described in this section.
1. Select the Traffic Map from the GTN Home page.
2. Verify that TIS FAIL is not displayed in the upper left corner under Traffic Status, and that NO
DATA (yellow) is not displayed over the ownship symbol.
3. On the upper left corner of the Traffic Map page, verify that the status of the traffic system is either
TIS Standby or TIS Operating/Unavailable (i.e. TAS should not be displayed).
The following additional steps should only be completed if the GTN is controlling the traffic system.
1. Pull the transponder circuit breaker and verify the air data fields are red ‘X’d.
2. If a squat switch (or airspeed switch) is connected to the GTX 33/330, ensure that it is in AIR
mode.
3. Alternately touch the Standby key and Operate key to change the mode of the traffic system. It
may take several seconds for the traffic system to change modes.
4. Verify that the mode of the traffic system can be changed.