Garmin GTN 6 series Maintenance Manual - page 60
Manual is about: Part 23 AML STC
of
106
Figure 5-4. Backshell Assembly (Potted
Configuration Module)
GTN 6XX/7XX Part 27 AML STC Maintenance Manual
190-01007-B1
Page 5-12
Rev. 1
Removal
1. Disconnect the connector from the GTN
backplate assembly.
2. Remove two screws (8) from cover (7) and
remove cover. See Figure 5-4 for this step.
3. Unplug the connector from the configuration
module (1).
4. Remove the configuration module from the
backshell connector.
Reinstallation
1. Inspect the connector for damaged pins (4).
2. Place the configuration module (1) in position.
3. Insert connector into the configuration module
(1).
4. Place the cover (7) back on the connector and
reinstall screws (8). See Figure 5-4 for this step.