I-Sotec i-soamp-2 Manual - page 10
–
10
–
Loudspeaker wiring diagram front loudspeakers:
The
i-soamp-2
, which drives the front loud-
speakers, is connected as described in Chapter 1.3.
Instead of the ISO loudspeaker receptacle of the
car radio, however, now the free ISO loudspeaker
receptacle of the split-adaptor AD-0124 is to be
used to connect the cable harness of the
i-soamp-2
to the car radio (Chapter 1.3, point 3).
1.5 Four loudspeakers + Subwoofer
With this connection
option the front
loudspeakers and the
rear loudspeakers are
driven by an
i-soamp-4
.
The bass loudspeaker is
driven by an
i-soamp-2
.
Signal distribution for
the amplifi ers is per-
formed via a separate
split-adaptor AD-0124
available from
i-sotec
.
Use only original i-sotec subwoofers! Other
loudspeakers can damage the i-soamp-2!
Due to the increased power demand for these
two amplifi ers it is important to connect the am-
plifi ers directly to the battery. See Chapter 1.7 for
additional information.
With this connection option, the selector switch
for the
i-soamp-4
is set to the „4 CH+Sub“
position. In this switch position the active fi lters
required for the front and rear loudspeakers are
automatically activated.
Setting
i-soamp-4