I-Sotec i-soamp-2 Manual - page 15
–
15
–
2. OPERATING THE EQUIPMENT FOR THE
FIRST TIME
1. Turn on the radio with the volume set at low.
2. After checking the operation of the individual
loudspeakers, set the volume of the radio a
little higher. If appropriate, now use the level
adjuster of the power amplifi er to adjust the
basic volume of the loudspeakers. The volume
ratio of the front and rear loudspeakers as well
as the subwoofer can now be adjusted with
the corresponding level adjusters (see
operating elements).
3. OPERATING ELEMENTS and CONNEC-
TIONS
1. Undervoltage indicator (low batt.) YELLOW
2. Excess temperature indicator (temp.) RED
3. Power indicator (radio ON) GREEN
4. System plug for power, loudspeaker input and
output
5. Remote input for connecting to the
i-soamp-
MM
. Use of the remote input (Rem.) is optional.
Normally the
i-soamp-2
is switched on with
the radio amplifi er. In connection with the
i-soamp-MM
(Multimedia Version) or with
the radio, which cannot switch on the
i-soamp-2
, this input is needed to switch on
the
i-soamp-2.
6. Loudspeaker control rear or subwoofer in the
front + subwoofer operating mode
7. Selector switch for operating mode
Low Batt.
Temp.
Radio On
Made in Germany
1
2
3
4
5
6
SUB
Normal
2 CH
-2
Made in Germany
2 CH + SUB
(extern)
7