I-Sotec i-soamp-2 Manual - page 9
–
9
–
The
i-soamp-2
has a max. current requirement
of 15A per amplifi er. In a few vehicles and when
connecting to two amplifi ers, the radio wiring
cannot cover this power requirement.
The
i-soamp-2
must then be connected directly
to the battery. (See 1.7)
Loudspeaker Wiring Diagram „Front + Sub-
woofer“
Loudspeaker wiring diagram subwoofer:
after the cable harness of the
i-soamp-2
has
been connected to the compact plug at the
i-soamp-2
, the subwoofer is connected as
follows:
1. The vehicle cable harness ISO loudspeaker plug
is removed from the car radio. The ISO loud-
speaker of the Y cable AD-0124 is connected
to the ISO loudspeaker receptacle of the car
radio.
2. The ISO loudspeaker of the i-soamp cable
harness is connected to one of the two ISO
loudspeaker receptacles of the split-adaptor.
3. The ISO loudspeaker receptacle of the
i-soamp
cable harness is not used.
4. The two 4-pole plugs are removed.
5. The 4-pole plug at the
i-soamp
cable harness
serves as a connector for the subwoofer.
Please use the original
i-sotec
subwoofer
connector cable for the connection or the
adaptor cable AD-0126 (subwoofer connector
cable 5m).
6. The power connection is made in accordance
with Chapter 1.7
7. The free ISO loudspeaker receptacle at the
split-adaptor is used for connecting the second
i-soamp-2
, which drives the front loudspeakers.