Intermec EasyCoder PD41 Installation Instructions

Page of 4

Download

Bookmark us

EasyCoder

PD41/PD42

Parallel IEEE 1284 Interface Installation Instructions

These instructions tell you how to install the Parallel IEEE 1284 Interface

Board in a EasyCoder PD41/PD42 printer. The kit includes the following:

• Parallel IEEE 1284 Interface Board with I/O Bus Cable

Required Tools

To install the interface board in your printer, you need these tools:

• Screwdriver, slotted

• Screwdriver, Phillips

Installing the Interface Board

Before you begin installation, please acknowledge the following important

safety notes:

The installation described in this section must only

be performed by an authorized service technician.

Intermec assumes no responsibility for personal

injury or damage to the equipment if the

installation is performed by an unauthorized

person.

Die in diesem Abschnitt beschriebene Installation

darf nur von einem autorisierten

Wartungstechniker durchgeführt werden. Intermec

übernimmt keine Verantwortung für Verletzungen

oder Sachschäden, falls die Installation von einer

unberechtigten Person durchgeführt wird.

Make sure the printer has been turned off and

disconnected from the power supply before you

start installation.

Stellen Sie sicher, dass der Drucker abgeschaltet

und von der Stromversorgung abgetrennt wurde,

bevor Sie mit der Installation beginnen.

1 2 3 4 Next › »

Page 1
Easycoder ® pd41/pd42 parallel ieee 1284 interface installation instructions these instructions tell you how to install the parallel ieee 1284 interface board in a easycoder pd41/pd42 printer. The kit includes the following: • parallel ieee 1284 interface board with i/o bus cable required tools to i...
Page 2
To install the parallel ieee 1284 interface board 1 turn off the printer and unplug the power cord.. 2 open the side door. Remove the two screws that hold the cover to the electronics compartment. 3 lay the printer down on its side, with the electronics compartment facing up. 4 loosen the electronic...
Page 3
5 slide the cover out along the rails and remove it from the printer. 6 put the printer back in upright position. 7 remove the small plate that covers the slot for the parallel board on the back of the printer. Keep the screws. 8 use the screws that were removed in step 6 to secure the parallel boar...
Page 4
Worldwide headquarters 6001 36th avenue west everett, washington 98203 u.S.A. Tel 425.348.2600 fax 425.355.9551 www.Intermec.Com © 2007 intermec technologies corporation. All rights reserved. 10 reattach the cover. When you turn on the printer, it automatically recognizes the parallel ieee 1284 inte...