Easylan ethernet software for the easycoder® pd41 and pd42 printers instructions.
Ii easylan ethernet software instructions intermec technologies corporation worldwide headquarters 6001 36th ave.W. Everett, wa 98203 u.S.A. Www.Intermec.Com the information contained herein is provided solely for the purpose of allowing customers to operate and service intermec-manufactured equipme...
Easylan ethernet software instructions iii contents introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 printer firmware requirements. . . . . . . . . . . . . . . . . . . . . . .5 setting network parameters from the printer home page . . .6 setting network paramet...
Iv easylan ethernet software instructions.
Easylan ethernet software instructions 5 introduction these instructions describe the various ways you can access and set the network parameters on a pd41 printer equipped with an easylan ethernet network card. The instructions apply equally to a pd42 printer, but are less relevant since network par...
6 easylan ethernet software instructions setting network parameters from the printer home page you can change all network parameters by using your web browser to access the printer home page. To access the home page, you need the ip address of the printer. As a default setting, the printer is set to...
Easylan ethernet software instructions 7 setting network parameters with printset 4 printset 4 is a pc-based software application that lets you configure your intermec printer from your computer. The program is available on the printercompanion cd, and can also be downloaded from the intermec web si...
8 easylan ethernet software instructions setting network parameters with fingerprint and ipl commands these instructions require that you start by establishing a serial connection between your printer and your pc. To establish a serial connection 1 use an rs-232 serial cable to connect the printer t...
Easylan ethernet software instructions 9 setting network parameters with fingerprint commands if your printer is running fingerprint firmware, you can modify all network parameters with the fingerprint setup command. To modify network parameters with fingerprint commands 1 establish a serial connect...
10 easylan ethernet software instructions n192.168.235.86, 255.255.255.0, 192.168.236.1 once you have set the parameters above you can use your web browser to access the printer home page and make the rest of your changes there. Setting ip address using arp’n’ping use the arp’n’ping method to set th...
Easylan ethernet software instructions 11 3 next, use ping to make the printer set the ip address: ping ip address 4 exit the command prompt..
Worldwide headquarters 6001 36th avenue west everett, washington 98203 u.S.A. Tel 425.348.2600 fax 425.355.9551 www.Intermec.Com easycoder pd41/pd42 easylan ethernet software instructions *943-130-001* p/n 943-130-001.
