Java wsd18-060 Operating Instructions Manual - page 12
9
Do not replace the replaceable hot water
nozzle(16)(see Fig. 5 )directly after drawing off water,
because the nozzle is hot after the draw‐off operation.
¾ At the start of the water draw‐off operation there can
be splashing avoid direct contact with the skin!
⑴ DISPLAY: READY
⑵ Place a cup under the replaceable hot water nozzle (16).
⑶ Open the steam / hot water draw‐off tap (14) (Fig. 13).
The illuminated ring (2) is active.
For example, 140 ML
WATER
⑷ Adjust the required water quantity by turning the Rotary
Switch(1).
For example, 200 ML
WATER
⑸ If the required water quantity is reached, the following
message is displayed:
DISPLAY: CLOSE TAP
⑹ Close the steam / hot water draw‐off tap (14).
DISPLAY: READY
12. Drawing off steam
To ensure perfect operation, clean the 2‐stage
frothing jet(15) regularly. Screw the nozzle off as
described in. Hold the nozzle at the top and at the
bottom end and screw it apart (Fig. 18). Thoroughly
rinse the 3 parts under running water.
¾ Make sure the nozzle has engaged properly. If the
nozzle is clogged with dried milk or has not been
attached properly, it might suddenly come off during
operation.
¾ During frothing some water will escape the system
before the actual frothing process. This does not affect
the result, e.g. when frothing milk.
¾ At the start of the steam draw‐off operation there can
be splashing The 2‐stage frothing jet becomes hot.
Avoid direct contact with the skin!
¾ Steam can be used for heating liquids and frothing
milk for cappuccino. Make sure that the replaceable
2‐stage frothing jet (15) is pushed upwards when
liquids are heated. To froth liquids, push the 2‐stage
frothing jet downwards, turning it slightly.
⑴ DISPLAY: READY
⑵ Press the steam pre‐selection key (8).
DISPLAY: HEATING
STEAM
READY
⑶ To draw off steam, open the steam/hot water draw‐off
tap (14) (Fig. 13).
The illuminated ring (2) is active.
⑷ You can adjust the steam draw‐off time individually by
turning the Rotary Switch (1) until the required SEC are
displayed.
For example, 35 SEC