Java wsd18-060 Operating Instructions Manual - page 9
6
⑼ Open the steam / hot water draw‐off tap (14) (Fig.13).
DISPLAY: RINSING
FILTER
CLOSE TAP
⑽ Close the steam/hot water draw‐off tap (14), now the
Coffee Machine will heat up to coffee temperature.
DISPLAY: HEATING
PRESS
RINSE
RINSING
READY
¾ Now you have activated the filter. In Programming
Mode the water hardness selection function is no
longer displayed.
5.2 Replacing the filter
¾ After drawing off approx. 50 litres or after 2 months,
the filter cartridge will be used up. A message
requesting you to replace the filter will appear on the
display.
⑴ DISPLAY: READY/FILTER
⑵ Switch off the COFFEE MACHINE using the ON/OFF key
(3).
⑶ Press the maintenance key (7) until the following
message is displayed:
DISPLAY: CHG FILTER
OPEN TAP
⑷ Remove the water tank from the machine and empty it.
⑸ Fold up the cartridge holder. Install the filter cartridge
in the water tank, applying a gentle pressure (Fig. 1).
⑹ Fold down the cartridge holder again until it engages
audibly.
⑺ Fill the water tank with cold, fresh tap water and
reinstall it.
⑻ Place a sufficiently large jug (approx 1 litre) under the
replaceable hot water nozzle (16) and open the
steam/hot water tap (14).
DISPLAY: RINSING
FILTER
CLOSE TAP
⑼ Close the steam / hot water draw‐off tap (14).
DISPLAY: HEATING
READY
E
6. Rinsing the Coffee Machine
¾ When the coffee machine is switched off and has
cooled down, a rinsing operation is started when the
machine is switched on again. When the machine is
switched off, a rinsing operation is started
automatically.
⑴ Switch on the coffee machine using the ON/OFF key
(3), the
power LED(22)is active.
DISPLAY: HEATING
PRESS