Java wsd18-060 Operating Instructions Manual - page 15
12
15.2 Programming the water hardness
Refer to Chapter 4 “Adjusting the water hardness”.
15.3 Programming the aroma INTENSIVE or STANDARD
¾ When the machine leaves the factory, the aroma is set
to Intensive. If requested it can also be set to
Standard.
⑴ DISPLAY: READY
⑵ Press programming key (4) until FILTER appears. The
program LED(23) and the illuminated ring (2) is active.
⑶ Turn the Rotary Switch (1) until Aroma is displayed.
DISPLAY: AROMA
⑷ Press the Rotary Switch (1).
DISPLAY: STANDARD
⑸ Turn the Rotary Switch (1) until the following message is
displayed:
DISPLAY: INTENSIVE
⑹ To confirm the new aroma settings, press the Rotary
Switch (1).
DISPLAY: AROMA
⑺ Press the programming key (4) to quit the
programming mode or select the next programming
item using the Rotary Switch (1).
DISPLAY: READY
15.4 Programming the temperature
⑴ DISPLAY: READY
⑵ Press programming key (4) until FILTER appears.
The program LED(23) and the illuminated ring (2) is
active.
⑶ Turn the Rotary Switch (1) until Temperature is
displayed.
DISPLAY: TEMP
⑷ Press the Rotary Switch (1).
DISPLAY: HIGH
⑸ Turn the Rotary Switch (1) to change the temperature
from HIGH to NORMAL (or vice versa).
DISPLAY: NORMAL
⑹ To confirm the new settings, press the Rotary Switch (1).
DISPLAY: TEMP
⑺ Press the programming key (4) to quit the
programming mode or select the next programming
item using the Rotary Switch (1).
DISPLAY: READY
15.5 Programming the time
¾ You must programme the time if you want to use the
automatic switch‐on function.
⑴ DISPLAY: READY
⑵ Press programming key (4) until FILTER appears.
The program LED(23) and the illuminated ring (2) is
active.
⑶ Turn the Rotary Switch (1) until TIME is displayed.