Java wsd18-060 Operating Instructions Manual - page 8
5
LEVEL 1 water hardness degree 1
LEVEL 2 water hardness degree 2
LEVEL 3 water hardness degree 3
LEVEL 4 water hardness degree 4
¾ When the Coffee Machine leaves the factory it is
adjusted to LEVEL 3.
You can adjust another hardness. To do this, proceed as
follows:
⑴ DISPLAY: READY
⑵ Press the programming key (4), the program LED(23)
and illuminated ring (2) is active.
DISPLAY: FILTER‐
⑶ Turn the Rotary Switch (1) until the following message is
displayed:
HARDNESS
⑷ Now press the Rotary Switch (1) to start the
programming.
DISPLAY: LEVEL 3
⑸ Turn the Rotary Switch (1) until the required level is
displayed.
For example, LEVEL 4
⑹ Press the Rotary Switch (1) to confirm the required level.
DISPLAY: HARDNESS
⑺ Press the programming key (4) to quit the
programming mode.
DISPLAY: READY
5. Installation of Claris plus filter cartridges
¾ If the Claris plus filter cartridge is installed properly,
de‐scaling of the coffee machine is no longer required.
5.1 Installing the filter
⑴ Fold up the cartridge holder. Install the filter cartridge in
the water tank, applying a gentle pressure (Fig. 1).
⑵ Fold down the cartridge holder again until it engages
audibly.
⑶ Fill the water tank with cold, fresh tap water and install
it again.
⑷ Press the programming key (4), the program LED(23)
and the illuminated ring (2) is active.
DISPLAY: FILTER‐
⑸ Press the Rotary Switch (1) to start the programming.
DISPLAY: NO ‐
⑹ Turn the Rotary Switch (1) until the following message is
displayed:
DISPLAY: YES√
⑺ Press the Rotary Switch (1) to activate the filter
cartridge.
DISPLAY: INSERT
OPEN TAP
⑻ Put a sufficiently large container (approx. 1 litre) under
the replaceable hot water nozzle (16).
¾ If not installed already, insert the Claris plus filter.