Kaco proLOG M Operator's Manual - page 10
Description of menu items:
Overview
Provides information about the current IP address of the
Ethernet connection. Also enables retrieval of the field
strength (for GSM devices).
y Ethernet
Current IP address: Shows the IP address currently
used within the LAN
y GSM
Field strength: Indicates the field strength.
Settings
The “communications” section can be used to set
various connection parameters, e.g. change IP address
or set the PIN code of the GSM card.
The “data logger” section can be used to start an
inverter scan, depending on which driver is activated.
In addition, the data logger can be reset to factory
settings.
Communication
Ethernet
Boot protocol
None:
No boot protocol is used
DHCP (Dynamic Host Configuration
Protocol)
:
A DHCP server assigns an IP address
to KACO-proLOG
BOOTP
(Bootstrap protocol):
BOOTP server assigns an IP address
to
KACO-proLOG
RARP (Reverse Address Resolution
Protocol):
RARP server assigns an IP address
to
KACO-proLOG
Static IP address:
Indicates the IP address used if no boot protcol
has been selected
Network mask:
Indicates the network mask being used;
(unless another mask is assigned by the
BOOTP or DHCP server)
Gateway:
Indicates the gateway being used
(unless another assignment has been made)
Modem/ISDN/GSM
Local IP address:
Defines the IP address of KACO-proLOG
in the WAN.
Remote IP address:
IP address to be assigned to the caller via the
WAN.
Subnet mask:
Defines the subnet mask in the WAN
(only for ISDN); Setting of MSN
PIN Code (only for GSM):
Setting of GSM PIN
Call-Accepted ON (analog only):
Active call-accepted restrictions are deleted.
y Data logger
Inverter scan
Allows searching (scanning) for inverters
Set factory settings:
Allows resetting to factory adjustments
ISDN:
Deletes MSN
Analog:
Enables “call accepted” function
Ethernet:
Sets IP address to 192.168.10.90
GSM:
Deletes the GSM PIN
Current values
Shows the current measuring values.
Various data can be retrieved, depending on which
devices are connected:
y Analog values
Shows analog measuring values
y Digital values
Shows the digital measuring values
y Current sensors
Shows the measuring values of the current
sensors
y Inverter
Shows the latest output of the individual inverters.
KACO SOLAR INC.
10
Operator’s Instructions KACO-proLOG