Kaco proLOG M Operator's Manual - page 24
7.2.2 Current sensors
If current sensors (KACO-go) are connected, the
current measuring values of these current sensors will
be displayed in this field.
7.2.3 Inverter Survey
If the inverters are connected and addressed properly,
the current and summed-up measuring values will be
displayed in this field.
Sum of all inverters showsa list of all connected
inverters, including the address, device status, current
grid-feeding capacity and daily yield obtained up until
the time of interrogation. Each inverter address is linked
to the inverter details.
7.2.4 Inverter details
This field provides a list of all measuring values.
Only one inverter at a time can be selected from the
drop-down list.
7.3 Status
7.3.1 Plant messages
This menu item provides a summary of possible alarm
statuses.
Measured value alarms are returned as a result of the
criteria predefined under “Admin – Monitoring ->
formulas -> Criterion 0 – 4“ .
The following information is listed in the status
summary:
• Designation:
Shows the name defined under “Formula/Criterion”
• Status:
Indicates if the criterion is defined as “active” or
“inactive”
• Upper limit:
Shows the current upper limit of the monitoring
criterion.
• Actual value: Shows the actual value of the
monitoring criterion.
• Lower limit:
Shows the current lower limit of the monitoring
criterion.
• Alarm counter:
Indicates how often the parameter has exceeded a
limit value.
• Transfer status:
Shows whether or not alarm messages are ready for
transfer at the moment.
• Info:
Shows the time of the last alarm occurred.
Plant alarms refers to messages concerning errors in
the monitoring system.
• Designation:
Indicates the cause of an error message.
• Alarm type:
Provides information on the type of alarm message
“Email / fax”.
• Alarm target (contact):
Shows the contact (recipient) the error message was
sent to.
• Alarm counter:
Indicates how often an alarm was triggered.
• Send status:
Shows whether or not alarm messages are ready to
send at the moment.
• Info:
Shows the time of the last alarm occurred.
Transfer status of emails provides information on the
current status of the system. If, for example, emails are
ready for transmission, the “Transfer status” will show
“busy”. The normal status is “ready to send”
KACO SOLAR INC.
24
Operator’s Instructions KACO-proLOG