Kalerm KLM1602 Operation manual - page 16
13
The drip tray should be cleaned before
cleaning brew unit. Because waste water
will be dripped to the tray.
Install the drip tray.
After istalling the drip tray, screen shows
“PRESS SETTING” to start.
The brew unit is cleaning.
Open the coffee powder container lid and
add the cleaning tablet, close the coffee
powder container lid and press the
cleaning button to clean the brew unit.
Brew unit is cleaning.
Empty the drip tray.
Instal the drip tray.
After cleaning finished, the machine enters
into “READY” status.
Cleaning and maintenance
Descaling the coffee machine
The daily usage will cause calcareous deposited in coffee
machine. The depositing rate vary with the local water
hardness.
Decalcifier contains acidic substances that would stimulate
your eyes and skin, so you must strictly comply with the
security warnings noted by manufacturer on the packaging.
If you have contacted it with your eyes or skin by accident,
please wash it with clean water immediately.
Only the original decalcifier can be used, use of other
decalcifier may cause damage to your coffee machine.
Dissolve the decalcifier in clean water, and then lead the
mixed liquid into the water tank. Fully dissolve the decalcifier
can descale the coffee machine more thoroughly.
The whole descaling process takes about 30 minutes.
The termination during the descaling process will damage
the coffee machine. So once you start the descaling process,
please do not terminate it midway.
After a centain time use, the screen will
display “NEED DESCALE” and “READY”
alternately. Now, press setting button to
enter the descaling program.
Press left and right button to choose
“MENU”, then press setting butoon to enter
into program setting menu.
Press left and right button to choose
“MAINTENANCE”, then press setting butoon
to enter into maintenance page.
READY
NEED DESCALE
MENU
MAINTENANCE
EMPTY TRAY
INSTALL TRAY
PRESS SETTING
CLEANING
CLEANING
ADD TABLET
PRESS SETTING
EMPTY TRAY
INSTALL TRAY
READY