Kalerm KLM1602 Operation manual - page 22
19
Transport
Please save the packaging of the coffee machine for future
transportation.
Make sure to empty water inside the machine before transportation,
otherwise, it will damage the machine.
After emptying the waterway, please wipe the machine both
inside and outside to dry.
Once the empty waterway program was executed, the system
will rerun to the program of “first-time use”, when the coffee
machine is used again.(
refer to
P6, First-time use)
While emptying the waterway, there will be a high-temperature
steam sprays from coffee spout. Please pay special attention to
avoid being scalded.
Transport and recycle
The machine is on the status of “READY”.
Take out the water tank, and the machine
indicates “FILL WATER TANK”.
Hold on pressing the cleaning button until
the screen shows "EMPTY UNIT", the
machine begins to clean up the waterway
automatically, and steam will spray from
the coffee spout, please keep distance to
avoid scalding.
After emptying the waterway, the machine
will automatically power off. Take the drip
tray out after the power is switched off, and
clear the water in the drip tray.
Recycle
When recycling the machine, some inner parts can be
recycled to use again. Please pay attention to recycle them
for environmental protection.
Voltage/Frequency
220VAC/50Hz
Power
1200 W
Pump pressure
15 bar
Capacity of water tank
1.8 L
Capacity of bean container
250 g
Capacity of coffee grounds container
15 cakes
Capacity of the brewing unit
7 - 14 g
Adjusting height of coffee spout
80 - 115 mm
Length of power cord
1.2 m
Net weight
11.5 kg
Dimensions (Length×Width×Height)
450mm
×
302mm
×
370mm
Technical Data
READY
FILL WATER TANK
EMPTY UNIT