Kalerm KLM1602 Operation manual - page 20
17
Display information
This chapter will instruct you the information shows on the
screen and the solutions.
Causes
Solutions
If the water drip tray is full, any
function of making beverage will
be out of service.
Take the drip tray out, empty the
waste water in the drip tray and
reinstall it to the machine.
If the coffee grounds container is
full, any function of making
beverage will be out of service.
Take the coffee grounds container
out, empty the coffee grounds
container and reinstall it.
If water in the water tank is used
up, any function of making
beverage will be out of service.
Fill the water tank with water.
If coffee beans in the bean
container are used up, function of
making coffee will be out of
service.
Add beans into bean container,
and press any button to release.
There is not enough coffee powder
in the powder container.
Next time when making coffee
with coffee powder, please put a
full spoon of powder.
The drip tray is not installed
correctly; any function is out of
service.
Install the drip tray correctly.
The water in the pipe inside the
machine is not enough; any
function is out of service.
Press any button to release to run
the water self-check system.
Temperature of the machine is too
high, the machine cannot be used.
Power off the main power, and use
it 1 hour later.
Temperature of the machine is too
low, the machine cannot be used.
Increase environmental temperature
to above 10
ą.
1. Line clossing; 2. Using dark
roasted coffee beans or over fine
coffee powder; 3. The filter of the
brewer is clogged.
1. Press any button to release to
run the self-check system; 2. Adjust
grinder wheel to rougher; 3. Start
brewer cleaning procedure (refer
to P12).
Internal parts stucked.
Press any button to run the self-test
system.
EMPTY TRAY
INSTALL TRAY
FILL BEANS
LACK OF POWDER
PRESSURE HIGH
BREW UNIT STUCK
TEMPERATURE HIGH
TEMPERATURE LOW
FILL WATER TANK
EMPTY GROUNDS
UNIT EMPTY