Kuschall Advance Service Manual - Service Manual
21
© Küschall AG, Switzerland | 2013-01
Service manual
Side parts
Replacing the clothes-guard
The mounting element
Ⓐ on the backrest must already be fitted.
Difficulty:
Tools:
Ã
3, 4 10
If present, remove the clothes-guard to be replaced by loosening the screw
connection
Ⓒ.
Check the correct position of the clothes-guard
Ⓑ with fitted rear wheel.
Here, find the suitable height on the clothes-guard
Ⓑ for fixing the screw
connection
Ⓒ to the backrest mount Ⓐ.
If necessary, replace the bolts
Ⓔ, holder Ⓓ on the seat plate.
i
The clothes-guard is correctly positioned if it can be inserted between
the seat module and the holder and the upper edge runs above the rear
wheel.
Fitting the mudguard
Difficulty:
Tools:
Ã
3, 4, 5
10 Ò 2
Remove the clothes-guard and the mounting elements on the backrest and the
seat.
Fit the holder
Ⓑ and underlays Ⓒ to the seat plate using the screw
connections
Ⓐ. Refit the rear wheel.
Slightly loosen the screws
Ⓓ on the adjustment plate and slide it along the
mudguard carrier until the mudguard is at the right height.
The position of the mudguard can also be adjusted: Here, loosen the screw
connections
Ⓔ and Ⓕ, position the mudguard as required and tighten the
screw connections
Ⓔ and Ⓕ again.
Tighten the screws
Ⓓ again.
Carry out the same setting on both sides.
By tightening or loosening the screws
Ⓖ you can adjust how easily the
armrest can be pulled out or pushed in.
i
The existing axle may not be sufficiently long for the new configuration
with mudguard. In this case, a longer axle must be fitted.
Chap. Rear
Wheels, Changing the wheel chamber / fitting and adjusting an axle.
The distance between the mudguard and the wheel must be
either 25 mm to prevent fingers from becoming caught
between the wheel and the mudguard.
A
D
E
C
B
E
Ⓒ
à 4 Nm
Ⓔ
à
7 Nm
Ⓐ à 7 Nm
Ⓓ à 4 Nm
Ⓔ
à
7 Nm
Ⓕ
à
7 Nm