Kuschall Advance Service Manual - Service Manual
25
© Küschall AG, Switzerland | 2013-01
Service manual
Rear wheels
Rear wheels
Attach vertical brace to the seat plate
Difficulty:
Tools:
Ã
5
The vertical brace can be infinitely adjusted on the seat plate.
Place the seat plate
Ⓒ reversed on the working area.
Push the sliding block
Ⓓ to the required position in the lower slot of
the seat plate
Ⓒ .
Attach the vertical brace
Ⓐ with bolts Ⓑ and washers through the
sliding blocks
Ⓓ to the seat plate Ⓒ.
Carry out the same setting on both sides.
Changing the wheel chamber / Fitting and
adjusting an axle
It is possible to attach two axels to the vertical brace.
Possible combinations, if two axles are attached
Vario Ax
0°
3°
6°
Vario Ax
✓
✓
✓
-
0°
✓
✓
✓
-
3°
✓
✓
✓
✓
6°
-
-
✓
✓
IMPORTANT!
Danger to axle and rear wheels from collisions.
When attaching the two axles make sure that the axles have the same
axle width.
Attach standard / Vario-Ax
Difficulty:
Tools:
Ã
3, 5
Position adjustable sliding block
Ⓕ in the groove of the vertical brace
and tighten with the
Ⓖ threaded pin.
Make sure that the adjusting sliding blocks are positioned at exactly
the same height both right and left.
Position in the sliding blocks
Ⓔ in the groove of the vertical brace.
Position the axle clamp
Ⓒ above the sliding blocks in the groove of the
vertical brace.
Position axle or Vario-ax
Ⓐ on the axle clamp Ⓒ.
Position axle clamp
Ⓑ on the axle.
If an antitipper is fitted, the axle clamp with end stop
Ⓗ must be
fitted instead of the axle clamp
Ⓑ.
Insert and tighten the bolts
Ⓓ through the axle clamp in the sliding
blocks.
Carry out the same setting on both sides.
Ⓑ à 7 Nm (
high-strength
)
A
B
Ⓓ à 7 Nm (
high-strength
)
Ⓖ
à
3 Nm (low-strength
)