Kuschall Advance Service Manual - Service Manual
29
© Küschall AG, Switzerland | 2013-01
Service manual
Rear wheels
Ensuring the rear wheels are parallel
Difficulty:
Tools:
Ã
5
Slightly loosen the bolts
Ⓐ on both axle clamps. Rotate the axle tube to
set the correct position.
Tighten the screws
Ⓐ on both side
s.
The distances
Ⓑ and Ⓒ need to be the same size.
i
This setting must be carried out on a horizontal surface. The track of
the rear wheels is correct if the distance between the rear wheels is
the same at the front and the back (x=y) – measured at the height of
the centre of the axle.
With a Vario-Ax the rear wheels are set in the 7° position to ensure
that they are parallel.
Adjusting the removable axle
Difficulty:
Tools:
11, 19
Remove the rear wheel.
Hold the end of the removable axle
Ⓑ using the straddle spanner.
Adjust the length of the removable axle by turning the nut
Ⓐ. The
length is correctly adjusted if the removable axle engages correctly
when fixing the wheel and wheel has just minimal clearance.
i
The wheels must be exchanged (left to right side and vice versa)
after adjusting both removable axles. The adjustment must now be
checked or carried out again to ensure the wheels can be switched.
Adjusting the wheel camber on the Vario-Ax
Difficulty:
Loosen the knurled screw
Ⓐ on the Vario-Ax.
Pull the rear wheel by the wheel hub
Ⓑ until the desired wheel
chamber is set. Possible settings are 1, 3, 7 and 10 degrees.
Tighten the knurled screw
Ⓐ again (not too tight)
Carry out the same setting on both sides.
Ⓐ à 7 Nm (
high-strength
)
$
%