Kuschall Advance Service Manual - Service Manual
6
© Küschall AG, Switzerland | 2013-01
Service manual
Overview
Overview
Seat width (SB)
Available seat widths: SB 340 to 460 in 20 mm steps.
Changing the seat width is very complicated. The seat module, the back-
rest, the real wheel axles and the footrest have to be replaced.
Seat depth (ST)
Available seat depths: ST 360 to 520 in 20 mm steps.
To alter the seat depth, the complete seat plate as well as the seat cushion
may need to be replaced.
Front seat height (SHv)
The front seat height is dependent on several factors that interact with
each other - Frames, forks and front wheel sizes.
Chap. Front wheels, Shift supporter on the frame,
Chap. Front wheels, Replacing a front wheel,
Chap. Front wheels, Replacing a front wheel fork,
Chap. Frame,
Mounting frame and seat plate.
Rear seat height
(SHh)
The desired seat height is achieved through the proper position on the rear
wheel fastener on the vertical brace. The vertical brace is available in two
sizes (short and long) covering seat heights from 370 to 490 mm.
The wheel position and the rear seat height are infinitely adjustable.
Chap. Rear wheels, Set axle position at the vertical brace.
Chap. Rear wheels, Tipping point adjustment.
Seat angle (SW)
The seat angle is determined by the difference between the rear seat
height (SHh) and the front seat height (SHv).