Kuschall Advance Service Manual - Service Manual
31
© Küschall AG, Switzerland | 2013-01
Service manual
Options & accessories
Options & accessories
Antitipper
There are two different sizes of antitipper for both the left and the right
sides.
Fitting an antitipper
Difficulty:
Tools:
Ã
5
10
Attach adaptation support
Ⓑ and Ⓒ with bolts Ⓐ to the axel.
Using bolts attach anti-tipper
Ⓓ to the adaptation supporterⒸ.
Measure the distance between the antitipper and the ground,
Chap. Options und accessories,
Adjusting the height of the antitipper.
Adjusting the length of the antitipper
Difficulty:
Tools:
Ã
3, 5
8
Press the adjustment button
Ⓔ on the antitipper and pull the antitip
tube into the desired position. Let the adjustment button latch into the
adjacent hole.
Adjusting the height of the antitipper
Difficulty:
Tools:
Ã
5
Loosen
Ⓐ bolts.
Turn adaptation supports
Ⓑ and Ⓒ with the antitipper on the axle
until the desired height above the ground is achieved.
Secure bolts
Ⓐ with safety adhesive(Loctite™).
Function check:
The distance between the antitipper and the ground must be 40 - 60 mm.
It must be easy to fold up the antitipper.
Tip the wheelchair backwards using the antitipper until the axle is perpen-
dicular to the antitipper’s point of contact with the ground. In this position,
the distance between the rear wheel and the ground must be at least
50 mm.
Adjusting the stop of the antitipper
Difficulty:
Tools:
Ã
3
Adjust the headless bolt A on the axle clamp D such that the distance
to the adjustment screw B in the adaptation support C is 1 mm.
x
x 50 mm
1 mm
Ⓐ
à 7 Nm (high-strength)
Ⓓ
à 7 Nm