Kuschall CHAMPION Service Manual - page 18
18
KÜSCHALL CHAMPION
© Küschall AG, Switzerland | 2013-12
Service Manual
FOOTRESTS
Fitting the footplate set to the front
The footplate is fitted set back as standard.
Difficulty:
Tools:
Ã4, 5
Remove the screws
and the screws
.
Remove the screws and washers
on both sides.
Rotate the footplate mounting
by 180°. The elongated side of
the footplate mounting
is now pointing forwards.
Fit the footplate mounting
again using the screws and
washers
.
Secure the footplate using the screws
and the screws
.
Set the desired footplate angle and tighten the screws
,
Chap. Footrests, Angle adjustment of the footplate.
Function control
Check that the footrest is firmly attached but that it can fold easily.
Angle adjustment of the footplate
Difficulty:
Tools:
Ã5
Slightly loosen the bolts
under the footplate which secure the
telescopic tube
to the footplate mounting
.
Set the footplate to the desired angle.
Tighten the bolt
on both sides.
Function control
Check that the footplate can fold easily.
Footrest mounted in high position
Difficulty:
Tools:
Ã4, 5
10
Remove the footrest from the frame.
Detatch the telescopic tube and footplate fixture
from the
footrest
by removing the screw .
Attach the mounting bracket
to the frame using the screws and
nuts
in the holes which are the closest to the frame.
Attach the footrest
at the desired height on the mounting
brackets
with the screws and the conical spacers .
Fit caps
to the ends of the frame.
Carry out the same setting on both sides.
1
2
3
4
à7 Nm
à7 Nm
à7 Nm
11
2
3
à7 Nm
1
8
3
7
1
6
4
5
22
4
à7 Nm
à7 Nm