Kuschall CHAMPION Service Manual - page 27
27
KÜSCHALL CHAMPION
© Küschall AG, Switzerland | 2013-12
Service Manual
OPTIONS & ACCESSORIES
OPTIONS & ACCESSORIES
Antitipper
Antitipper assembly
Difficulty:
Tools:
Ã6
22
19
Remove the nut
.
Mount the antitipper
with the adapter sleeve , the nut , the
sleeve
and the screw to the adapter plate .
i
If an antitipper is newly fitted, the short adapter sleeve
must be
replaced with a longer one in certain circumstances
(only applies to 1° wheel camber).
Height adjustment
Press the spring pin
. Slide the inner part of the antitipper to
the required position until the spring pin
locates in the correct
hole.
Function control:
The distance between the antitipper and the ground must be
40 - 60 mm. It must be easy to fold up the antitipper.
Tip the wheelchair backwards using the antitipper until the axle is
perpendicular to the antitipper’s point of contact with the ground. In
this position, the distance between the rear wheel and the ground
must be at least 50 mm.
1
2
3
4
5
8
7
6
à35 Nm
à13 Nm
x
x 50 mm