Kuschall CHAMPION Service Manual - page 29
29
KÜSCHALL CHAMPION
© Küschall AG, Switzerland | 2013-12
Service Manual
OPTIONS & ACCESSORIES
Cane holder
Cane holder assembly and adjustment
Difficulty:
Tools:
Ã5 Ò2
Attach the mounting block
onto the wheelchair using the 2
bolts
.
Attach the horizontal adaptation support
to the mounting
block
using the 2 bolts .
i
If a tipper aid is mounted on the other side of the wheelchair, then
an additional mounting block is needed to lower the cane holder
to prevent them clashing together when the wheelchair is folded.
Slide the cane holder
into the horizontal adaptation support
and fasten it with the spring clip
.
Remove the screw
from the backrest cover then replace it
together with the strap
.
Function control:
The cane holder must not touch the floor when the wheelchair is
tipped backwards.
If the cane holder touches the floor remove it and change the
position of the spring clip
. This is done by removing the tube
end cap then pushing the spring clip
one hole further into the
tube using a screwdriver.
Fitting the pelvic belt
Difficulty:
Tools:
Plastic hammer,
à 5,
10
Fit the steel strap
with the bolt on both sides of the side
profile
, pressing the upper part of the steel strap inwards, e.g.
using a plastic hammer.
Ensure that the webbing of the pelvic belt is not twisted during
assembly and the locking mechanism shows towards the front.
Ensure that the seat cover does not get caught between the steel
strap and the side supporters during assembly.
7
8
2
1
3
4
5
6
à7 Nm
à7 Nm
à4 Nm
ᆰ
ᆱ
ᆲ
ᆲ
ᆲ
à7 Nm