Kuschall CHAMPION Service Manual - page 23
23
KÜSCHALL CHAMPION
© Küschall AG, Switzerland | 2013-12
Service Manual
FRONT WHEELS
Front wheels, repositioning to the frame
The front forks can be mounted in 3 different positions on the front
frame. If the distance between footplate and front wheel is too small
or if the footrest is mounted in high position, only the two rearmost
positions can be used. With the carbon frame and the titan frame
75° having only two pairs of holes, just the rearmost position can be
used.
Difficulty:
Tools:
Ã5
10
Remove screws with washers
and the nuts .
Place the front wheel supporter
in the required position on the
frame
then replace the screws and washers and the nuts .
Check the position of the front wheel supporter,
Chap. Front
wheels, Front wheel supporter, vertical adjustment.
The bearing block can be fitted with the holes to the front or with the
holes to the back. Fitting with the holes to the back only makes
sense if there is enough space between the castor wheel and the
footplate.
Front wheel supporter, adjusting the steering
error angle
Difficulty:
Tools:
Ã5
10
Remove nut
and slightly loosen screw .
Place a spirit level against the bearing block
and turn the disc
with an allen key so that the bearing block is perpendicular to the
floor.
Tighten screw
.
Replace and tighten nut
.
Front wheel supporter, adjusting the trail
angle
Difficulty:
Tools:
Ã5
10
The trial angle of the front wheels is set and fixed when assembling
the frame,
Chapter Frame, Changing frame.
1
4
3
2
à13 Nm
à7 Nm
A
B
90˚
2
1
3
4
à13 Nm
à7 Nm
90°