La Cornue 110 Induction User Manual - page 21

19

If you are cooking a large item, be prepared to turn it 

round during cooking.

If two shelves are used, check that space has been left 

for the heat to circulate. When a baking tray is put into 

the oven, make sure that it is placed centrally on the 

shelf.

Check that the door seal is not damaged and that the 

door catch is adjusted so that the door is held firmly 

against the seal.

A dish of water when placed on the shelf should be the 

same depth all over. (For example, if it is deeper at the 

back, then the back of the cooker should be raised up or 

the front lowered.) If the cooker is not level, arrange for 

your supplier to level it for you.

Oven temperature getting hotter as the cooker gets older

If turning the temperature down using the oven control 

knob has not worked, or has only worked for a short 

time, then you may need a new thermostat. This should 

be fitted by a service person.

The oven light is not working

The bulb has probably burnt out. You can buy a 

replacement bulb (which is not covered under the 

guarantee) from a good electrical shop. Ask for a 15 W – 

230 V lamp, FOR OVENS. It must be a special bulb, heat 

resistant to 300 °C (Fig.6.1).

Before removing the existing bulb, turn off the power 

supply and make sure that the oven is cool. Open the 

oven door and remove the oven shelves.

Locate the bulb cover and unscrew it by turning it 

counter-clockwise (it may be very stiff) (Fig.6.2).

Now unscrew the existing bulb counter-clockwise, 

taking care to protect your fingers with a glove in case 

the bulb should shatter.

Screw in the new bulb clockwise and then screw the 

bulb cover back on. Turn on the electricity supply and 

check that the bulb now lights.

The oven door is misaligned

The bottom hinge of either oven door can be adjusted 

to alter the angle of the door (Fig.6.3). Loosen the 

bottom hinge fixing screws and use the notch and a flat 

bladed screwdriver to move the position of the hinge to 

set the hinge position (Fig.6.4).

Retighten the hinge screws.

ArtNo.324-0005  Oven light bulb

Effect of hinge adjustment – exagerrated for clarity

ArtNo.320-0007 Oven door hinge adjustment 2

Centreline of hinge pin

Oven door omitted for clarity

Fig.6.1 

Fig.6.2 

Fig.6.3 

Fig.6.4