La Cornue 110 Induction User Manual - 8. Servicing

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

26

nn

Disconnect the cooker from the electricity supply 

before servicing, particularly before removing any 

of the following: control panel, side panels, ceramic 

hob, or any of the electrical components or cover 

boxes.

nn

Before reconnection, check that the appliance is 

electrically safe.

1.  To Remove the Control Panel

a).  Disconnect the appliance from the electricity supply.

b).  Remove the control knobs from all the controls.

c).  Open the left-hand and right-hand doors. Remove 

the 3 fixings from the control panel front and 3 

fixings on the control panel underside.

d).  Pull the control panel forward and remove the 

connections from the 2 neons. Lift the panel clear.

e).  Replace all parts in reverse order.

f).  When replacing any electrical connections refer to 

the wiring diagram.

2.  To Lift up the Induction Hob

a).  Disconnect the appliance from the electricity supply.

b).  Pull the unit forward to gain access.

c).  Remove the Control Panel as detailed in Section 1.

d).  Remove the 2 hob retaining screws from each side of 

the hob.

e).  Lift the front of the hob.

f).  Replace in reverse order.

3.  To Remove a Side Panel

a).  Disconnect the appliance from the electricity supply.

b).  Remove the control panel as detailed in Section1.

c).  Undo the lower retaining screw situated below the 

edge at the panel front corner (Fig.8.1). 

d).  Remove the front side panel retaining screws and the 

2 on the rear of the side panel. Remove the panel by 

pulling it away from the range (Fig.8.1).

e).  Replace parts in reverse order.

4.  To Remove an Oven Neon

a).  Disconnect the appliance from the electricity supply.

b).  Remove the control panel as detailed in Section 1.

c).  Remove the relevant neon connection and undo the 

nut which secures the neon to the control panel.

d).  Replace parts in reverse order. Make sure the

e).  replacement neon functions correctly.

8. Servicing

Fig.8.1