La Cornue 110 Induction User Manual - page 31
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
29
12. To Remove the Door Latch
a). Remove the screws that secure the latch assembly to
the inner door panel. Fit the replacement latch and
re-assemble in reverse order (Fig.8.6).
b). Check correct operation of door.
13. To Remove the Oven Door Seal
a). Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook
is released (Fig.8.7).
b). Proceed to the next hook and release it in a similar
way, and so on. Use force if the hooks are stiff, as the
old seal will be discarded.
c). When fitting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes
of the door, and proceed round the door snapping in
each hook in turn.
14. To Remove Oven Inner Back
a). Open the oven door. For the left-hand oven unscrew
the 2 thermostat phial fixing screws. Remove the
fixings that secure the inner back to the oven rear
(Fig.8.8).
b). Lift the removable panel away.
c). Re-assemble in reverse order. Ensure that the
retaining fixings are fully tightened.
15. To Replace an Oven Fan
a). Disconnect the appliance from the electricity supply.
b). Pull the unit forward to access the cover boxes at the
rear of the appliance. Remove the fixings that secure
the cover and lift it clear.
c). Remove the fan wiring, noting the connection
positions.
d). Remove the inner back as detailed in Section 14.
e). Hold the fan blades and undo the centre nut (LH
thread), brass washers, fan blade and circlip.
f). Undo the fixings that retain the fan and remove it
from the cavity rear.
g). Fit the replacement and re-assemble parts in reverse
order. Check that the oven operates satisfactorily.
16. To Remove an Oven Fan Element
a). Disconnect the appliance from the electricity supply
b). Pull the unit forward to access the cover boxes at the
rear of the appliance. Remove the fixings that secure
the cover and lift it clear.
c). Undo the terminal connections noting their
positions.
d). Remove the inner back as detailed in Section 14.
e). Remove the fixings that secure the element within
the oven and lift the element away carefully (Fig.8.9).
ArtNo.320-0005 Oven door rubber seal
ArtNo.320-0020 Oven back fixing screws
Element fixing screws
ArtNo.321-0005 Fan oven element
Fig.8.6
Fig.8.7
Fig.8.8
Fig.8.9