La Cornue 110 Induction User Manual - page 30

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

28

g).  Left-hand oven only -  

h).  Pull the unit forward to access the rear of the cooker.

i).  Remove both cover boxes by removing the fixing 

screws and lifting clear. Feed the thermostat capillary 

clear of the oven.

j).  Disconnect the wires from the thermostat and undo 

the two fixings which secure the control to the 

mounting plate.

k).  Fit the replacement and re-assemble in reverse order. 

Ensure that the phial is screwed to the oven rear, 

positioned centrally between the clips. Check that 

the thermostat functions correctly.

9.  To Remove an Oven Cut-off Thermostat

a).  Disconnect the appliance from the electricity supply.

b).  Pull the unit forward to gain access to the cover box. 

Undo the cover screws and lift clear.

c).  The control is located on the earth plate beside the 

oven element connections.

d).  Disconnect the thermostat wiring. Undo the fixings 

that secure the thermostat to the earth plate and 

remove.

e).  Fit replacement control and re-assemble parts in 

reverse order.

10.  To Remove the Oven Door (Fig.8.3)

a).  Door is very heavy - take care.

b).  Open the oven door.

c).  Support the door and remove the two screws which 

secure the upper hinge to the front frame of the unit.

d).  Remove the door from the lower hinge by lifting 

slightly and moving it outward.

e).  Re-assemble in reverse order.

11.  To Change the Oven Outer Door Panel or  

Door Trim Parts

a).  The door outer panel and all the trim parts are 

available as separate spares so that individual parts 

can be changed.

b).  Unscrew the door handle and remove the handle and 

door trim handle disk (Fig.8.4).

c).  Open the oven door. 

d).  Remove the hexagon headed screws ‘A’ and ‘B’ (two 

each side) from the door (Fig.8.5).

e).  Carefully lift off the door outer.

f).  Place the outer panel on a clean flat surface.

g).  The door trim handle plate is held in place by screws 

on the inside. Studs and nuts hold the other trims.

h).  Replace the damaged parts and re-assemble in 

reverse order.

ArtNo281-0144 Unscrew Door Knob

Fig.8.3 

Fig.8.4 

Fig.8.5