La Cornue 110 Induction User Manual - page 27
25
INSTALLATION
Check the appliance is electrically safe when you have finished.
ArtNo.280-0053 Door Knob Screw to Door (Numbers at bottom)
ArtNo.350-0017 - Securing the plinth
Fitting the Door Handles
Fit the door knobs to door knob bases and screw them on to
the mountings on the oven doors. Hand tighten only – do not
use any tools (Fig.7.18).
Fitting the Plinth
Remove the 3 screws for the plinth mounts along the front
bottom edge of the cooker (Fig.7.19). Fasten the plinth using
these screws.
Refitting the Storage Drawer
1. Note: To avoid exterior damage to the storage drawer.
Ensure a soft cushioned mat is placed on the floor and
covers the width and depth of the storage drawer.
2. Align the two holes on either side of the storage drawer
with the runner brackets (Fig.7.20).
3. Fasten the two fasteners and screw washers on either
side of the storage drawer.
4. Close drawer and check the alignment. Adjust storage
drawer position accordingly.
5. Check the alignment is correct and ensure all fasteners
are fully tightened.
Final Checks
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Oven Check
Turn on the ovens. Check the oven fans start to turn and that
the ovens heats up.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
Fig.7.18
Fig.7.19
Fig.7.20