La Cornue 110 Induction User Manual - page 25

23

INSTALLATION

Check the appliance is electrically safe when you have finished.

ArtNo.010-0004 Moving the cooker 

Removing the Storage Drawer

1.  Note: To avoid exterior damage to the storage drawer. 

Ensure a soft cushioned mat is placed on the floor and 

covers the width and depth of the storage drawer.

2.  Slide the storage drawer out until it stops.

3.  Unscrew the two fasteners and remove the screw 

washers from either side of the storage drawer runner 

brackets (Fig.7.9). 

Lowering the Two Rear Rollers

To adjust the height of the rear of the cooker, first fit a 13 mm 

spanner or socket wrench onto the hexagonal adjusting nut 

(Fig.7.10). 

Rotate the nut – clockwise to raise – counter-clockwise to 

lower. Make 10 complete (360°) turns clockwise.

Make sure you lower BOTH REAR ROLLERS. 

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the 

oven doors so that you can get a good grip on the bottom of 

the fascia panel as you move the oven (Fig.7.11).

Carefully push the cooker backwards off the base tray. 

Remove the base tray.

Position the cooker close to its final position, leaving just 

enough space to get behind it (Fig.7.12).

n

n

Do not use the door handles or control knobs to 

manoeuvre the cooker.

Repositioning the Cooker Following 

Connection

If you need to move the cooker once it has been connected, 

make sure it is switched off at the supply switch before 

gripping under the fascia panel and lifting the front of the 

cooker slightly (Fig.7.11). Check behind the cooker to make 

sure that the electricity cable is not caught. 

As you progress, always make sure that the cable has 

sufficient slack to allow the cooker to move.

When you replace the cooker, check behind it again once 

more to make sure that the electricity cable is not caught or 

trapped.

Levelling the Cooker

It is recommended that you use a spirit level on a shelf in one 

of the ovens to check for level.

Place the cooker in its intended position. Take care not to 

twist it within the gap between the kitchen units as damage 

may occur to the cooker or units.

The front feet and rear rollers can be adjusted to level the 

cooker. To adjust the height of the rear of the cooker use 

a 13 mm spanner or socket wrench to turn the hexagonal 

adjusting nuts at the front bottom corners of the cooker.

To set the front turn the feet bases to raise or lower.

Fig.7.9 

Fig.7.11 

Fig.7.10 

Fig.7.12