Labgear HDSR 260 Setup Manual - 7 Dish Setup
Customer Careline: 08457 573 479 (Local rate - UK Only) Technical Support: www.philex.com/support 11
7 Dish Setup
If you have a fixed satellite dish with a single LNB
there is no need to alter any settings you can scan
for channels straight away (Section 6).
Choose satellites by using the / keys, you can
choose one or more, press the OK key to confirm.
Note: Only select satellites which your dish can
receive a good signal from, when you change the
selected satellite, you may need to adjust the dish.
7.1 Transponder
Transponder information is pre-programmed unless
there has been a recent alteration there is no need to
alter any settings. If you do need to alter settings,
press the GO TO key to enter the screen to the right.
This Menu allows you to edit the various options for
the transponder (TP) settings and specifications.
In this menu, press GOTO key to return to the
satellite list; use the / keys move the cursor on a
transponder, then press OK to select a transponder,
you can select more transponders in this way; press
the EXIT key to exit.
Edit a transponder: Select a transponder then press
the green key, you can edit the No., frequency,
symbol rate and polarity of the transponder.
Add a transponder: Press the red key, then input the
No., frequency, symbol rate and polarity of
the transponder.
Delete a transponder: Select a transponder then
press the yellow key, then a dialogue box will
appear, press ok to delete and press EXIT to exit.
Scan a transponder: Select a transponder then press
the blue key, set up the channel search and press ok.
7.2 Edit a satellite
Select a satellite then press the green key.
You can change the No., name, Longitude Direction,
Longitude Angle and the Band information of
the satellite.
7.3 Add a satellite
Press the red key. Then input the No., name,
Longitude Direction, Longitude Angle and the
Band information of the satellite.
7.4 Delete a satellite
Select a satellite then press the yellow key, a
dialogue box will appear, press OK to delete and press EXIT to exit.
After satellite setup, press the key to make other dish settings. Press / keys to select an option.
LNB Type: Press the / keys to select the LNB type which matches the one used in the dish.
When you choose User Single and User Dual, please input the frequencies of the LNB used.
LNB Power: Set the LNB power as appropriate using the left or right key.
22KHz: Set 22KHz option as appropriate using the / keys.
Toneburst: Set the Toneburst as appropriate using the / keys.
DiSEqC1.0: If your receiver is connected to a 4 port switch, select the port (LNB1-LNB4) using the / keys.
DiSEqC1.1: If your receiver is connected to a 16 port switch, select the port (LNB1-LNB16) using the / keys.
Motor: See section 8 on the next page