Labgear HDSR 260 Setup Manual - 8 Motorised Dish Setup
Customer Careline: 08457 573 479 (Local rate - UK Only) Technical Support: www.philex.com/support
12
8 Motorised Dish Setup
If you have a USALS motorised system, you can set
the dish position in the USALS menu of your
satellite receiver. Ignore this section if you do not
have a motorised dish.
DiSEqC Type:
Select DiSEqC1.2 or DiSEqC1.3 in
Motor, press / and OK key, the screen opposite
appears, you can set the dish position in this menu.
8.1.1 Move Auto:
Select Move Auto, press key,
the dish will move West, press key, the dish will
move East, In this mode, the dish will move
automatically, when the receiver receives TV signal
from the dish, it will stop. You can also choose stop
by pressing the or key.
8.1.2 Move Continue:
Select Move Continue, press key, the dish will move West, press key, the dish will move
East, In this mode, the dish will move continuously, the dish will stop moving only when you choose stop.
8.1.3 Move Step:
Moves the dish step by step to find the optimum position to receive a satellite’s signal, you can
adjust the step size in increments from 1-9 by using the numeric keys. Select Move step, press the numeric keys to
change the step size, then press key, the dish will move West for one step, press key, the dish will move East for
one step, you can move the dish for more steps by pressing the left or right key.
8.1.4 Store Position:
Stores the current position of the dish.
8.1.5 Goto Position:
Moves the dish to the last stored position
8.1.6 Goto Reference:
Moves the dish to the original position.
8.1.7 Goto X:
Moves the dish to the longitude and latitude you set.
Select DiSEqC1.3 in Motor, press the red key, the
screen opposite will appear, you can then set the
limits for dish movement in this menu.
8.2 Set Limit
8.2.1 Move Continue:
Select Move Continue,
press key, the dish will move west, press key,
the dish will move east, In this mode, the dish will
move continuously, the dish will stop moving only
when you choose stop.
8.2.2 Move Step:
Moves the dish step by step to
adjust to get the best place to receive TV signal,
you can adjust the step size in increments from
1-9 by using the numeric keys.
8.2.3 Set West/East Limit:
In some locations, the dish can only move safely within a certain range, and therefore it
is necessary to set limits to the dishes movement. When the dish reaches an obstruction you need to set this position
as the limit.
8.2.4 Goto Reference:
Returns the dish to the original position.