Labgear HDSR 260 Setup Manual - 3 Connections
Customer Careline: 08457 573 479 (Local rate - UK Only) Technical Support: www.philex.com/support
7
3 Connections
This section explains the installation of your HDSR260 it is also recommended that you consult the manuals supplied
with equipment you are connecting your HDSR260 to.
3.1 Connect to the TV using an HDMI or SCART lead (not supplied).
1. Connect the satellite coaxial downlead from the LNB situated on the dish to the LNB IN connector.
2. Connect the satellite receiver to the TV using either an HDMI or SCART cable.
3. Plug the power adaptor into a mains socket and connect to the DC socket on the back of your combo receiver.
3. 2 Satellite dish connections
Choose which satellite you want to receive your signals from, for the UK this will usually be Astra 2 28.2 East, use
www.dishpointer.com, to find the compass bearing, azimuth and elevation for your dish or ask a CAI registered
installer to install your dish. Once the dish is installed. Connect one end of the coaxial cable to your LNB and then
attach the other end of the coaxial cable directly to the LNB RF IN connector of your receiver.
For multiple satellite connections:
Ignore this section if you are using a standard fixed dish with a single LNB
If you want to watch programs from more than one satellite (For example from Astra and Hot Bird) using fixed dish/
dishes and a DiSEqC 1.0 switch. Connect both the LNB’s with coax cables to the IN connectors on the DiSEqC 1.0
switch. Connect the OUT connector on the DiSEqC 1.0 switch to the LNB IN connector at the back of your receiver.
Alternatively you can watch programmes from multiple satellites is by mounting a dish to a motorized DiSEqC 1.2
positioner. Connect the OUT connector of the motor/positioner via a coaxial downlead to the LNB IN connector at
the back of your receiver.
3.3 Switching on the unit for the first time
Ensure all connections have been made as shown in the diagram above. To switch on your HDSR260, press the Power
button on your HDSR260.