Labgear HDSR 260 Setup Manual - 14 Troubleshooting
Customer Careline: 08457 573 479 (Local rate - UK Only) Technical Support: www.philex.com/support 19
14 Troubleshooting
There are a variety of reasons why the receiver may not function as expected.
The table below lists symptoms that might occur and the causes and appropriate remedies.
If you are still unable to get your receiver operating properly, please contact our customer careline - details shown in
the footer. Don’t under any circumstances remove the receiver cover as you could risk receiving an electric shock.
Symptom
Cause
Remedy
The LED display on
front panel does
not light up.
The power cord is not plugged
in.
Check that the power cord is plugged in
to the wall outlet.
No picture or
sound
Check the connection(s) from
the Audio/ Video output of
the receiver to input of TV. The
Audio is muted or the TV is Off
Connect the Audio/ Video output of the
receiver to TV correctly. Press the MUTE
key and Turn the TV on.
No picture or
picture freezes
The receiver can’t receive the
signal, The dish/aerial is not
aligned correctly, Incorrect
values of the tuner parameters,
The TV has the wrong Input
selected, the brightness and/or
contrast are set too low .
Check the dish/aerial cable, replace the
cable and securely connect the cable to
the receiver. Set the values of the tuner
parameters correctly in the installation
menu [Use default values]. Check the
signal strength with a signal finder me-
ter and adjust the dish/aerial correctly.
No picture
The program is a radio program
Press
mode.
The remote control
does not work
The batteries of the remote
control are not inserted or
exhausted, the IR remote signal
is being blocked
Check that the batteries are inserted
correctly. Check the batteries condition
and if exhausted replace the batteries in
the remote control.
Make sure nothing is obstructing the
path of the remote control signal
15 Specifications
Input
DVB-S2 RF IN, USB 2.0
Output
USB 2.0, HDMI (HD Audio & Video), SCART (SD Audio & Video)4x Phono: Digital Audio (coaxial),
Left/Right Audio (analogue), Composite Video, RF loop through
Specifications
Dimensions:
W 220.0mm H, 38.0mm, D 160.0mm
Cable Length:
1m
Mains adaptor:
Max 8W,100-240V~50-60Hz
Input frequency:
950 to 2,150MHz
Symbol Rate:
1 to 45M
Demodulation:
QPSK, 8PSK, 16APSK, 32APSK
Input Impedance:
75Ω