Lantronix Device Server MSS 485 Installation Manual - 4 - Configuration

Configuration

Command Set 

4 - 1

4 - Configuration

Certain parameters must be configured before the MSS can function in 

the network. EZWebCon is the recommended way to communicate with 

and configure the MSS. This chapter shows an additional method of 

configuration: the command line interface and MSS command set. 

NOTE:

Instructions for using EZWebCon are included with the soft-

ware. EZWebCon also has on-line help to assist you with con-

figuration.

4.1 Command Set

The command line interface allows users to enter commands at the Local 

prompt to configure, monitor, and use the server. This chapter covers 

many of the MSS commands. The full command set is discussed in detail 

in Chapter 6, Commands,in the MSS Reference Manual located on CD-

ROM.

NOTE:

To return to factory defaults, press and hold the Reset button 

while cycling power on the unit, or enter the Initialize Factory 

command at the Local> prompt.

4.2 System Passwords

There are two important passwords for the MSS: the privileged password 

and the login password. These passwords have default settings and are 

discussed in the following sections.

4.2.1 Privileged Password

Only the privileged user can change server or port settings. To become 

the privileged user, enter the following command. The default privileged 

password is system.

Figure 4-1:  

Set Privileged Command

Local> SET PRIVILEGED