Mackie TT24 Owner's Manual - 3.1
Mackie TT24 Digital Live Console Owner’s Manual
23
Chapter 3: Console Surface Controls
The TT24 console surface is organized into the following areas, each of which
is discussed in this chapter:
• Channel Strips
• QuickMix
• Bank Select
• V-Pot Control
• Utility
• Flex-Groups and Master
• Solo
3.1
Channel Strip
The TT24 has 24
channel strips
bounded at the bottom by a fader and at the
top by a LINE switch. Each channel strip can control one input at a time from
one of four banks.
The top section of each channel strip (left of Figure 3-1) has the following analog
controls that apply only to the Analog bank: LINE mic/line input switch, 48V
phantom power switch, GAIN mic/line gain control, and OL (overload) and SIG
signal LEDs.
Below that, each channel has a virtual potentiometer (V-Pot), MUTE, SELECT,
and SOLO buttons, and a 100-mm motorized fader (right of Figure 3-1).
The V-Pot knob, which performs multiple channel functions one at a time,
consists of a push-button rotary encoder surrounded by a 15-segment LED
ring (see
V-Pot Control Area
on page 29).