Mackie TT24 Owner's Manual - 4.1
Mackie TT24 Digital Live Console Owner’s Manual
43
Chapter 4: Rear Panel Connectors
4.1
Analog I/O
Figure 4-1 shows the rear panel analog I/O connectors except for the Group/
Matrix outputs, which are shown in Figure 4-3.
Figure 4-1 Analog I/O
4.1.1
MIC Inputs 1–24
The TT24 microphone preamp was based on our extensive knowledge and
experience with those used in the Digital 8•Bus, VLZ Pro, and Onyx Series
mixers, but optimized for a digital mixer.
These female XLR connectors accept a balanced microphone input from almost
any type of microphone. The LINE button on the channel strip should be in the
up
position when using these connectors. The MIC inputs appear on the ANALOG
fader bank. Phantom power (48 VDC) can be switched on for condenser mics
setting the 48V button to the
down
position.
The XLR inputs are wired according to the AES standard:
• Pin 1 = Shield or ground
• Pin 2 = Positive (+ or hot)
• Pin 3 = Negative (- or cold)
CD/TAPE A
TALKBACK
OUT
IN
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
LINE
INSERT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
CTR/MONO
RIGHT
LEFT
MONITOR
MAINS OUT
LINE INPUTS
AUX SENDS
1
2
3
4
5
6
7
8
9
10
11
12
L
R
C
24 Mic, Line
and Insert
Analog
Inputs
12 Aux
Sends
8 Analog Line Inputs
Monitor
Outputs
CD/Tape B
Inputs
CD/Tape A
Inputs/Outputs
Talkback
Input
Main Outputs
R
M
L
1
2
3
4
5
6
7
8
R
L