Mackie TT24 Owner's Manual - 3.5
Mackie TT24 Digital Live Console Owner’s Manual
Console Surface Controls
38
If any channel is soloed, the RUDE SOLO LED flashes red. The L and R meters
now display the stereo solo signal instead of the main output. If the solo signal
is mono, it appears on both the L and R meters.
The CTR/MONO meter does not display anything when viewing solo levels.
This, along with the RUDE SOLO LED, indicates that the meter is displaying
a soloed signal.
When all solos are cleared either individually or by pressing the global CLEAR
SOLO button, the RUDE SOLO LED stops flashing and the three meters return
to their normal operation.
3.5
UTILITY Area
At the top of the console, the UTILITY area contains TALKBACK, MONITOR,
and PHONES controls.
Figure 3-7 UTILITY area
3.5.1
TALKBACK
The TALKBACK gain knob controls the input gain of the rear panel TALK-
BACK microphone input. The gain range is 0–60 dB. A green SIG (signal) LED
and a red OL (overload) LED behave identically to those on the channel strips
(see page 25). The talkback signal is routed via the TALKBACK Touchscreen,
accessed by pressing UTIL and then touching the TALKBACK button. The
Talkback signal can be routed to any Matrix or Aux bus.
3.5.2
MONITOR
The MONITOR gain knob controls the level of the Left, Right, and Mono monitor
outputs. The gain range is from
off
to +10 dB. These outputs contain the left,
right, and monitor signal selected in the MON. SOURCE Touchscreen, accessed
by pressing UTIL and then touching the MONITOR SOURCE button. When a
solo button is pressed, the solo signal is sent to the monitor outputs instead.
OL
SIG
U
OFF
MAX
MONITOR
U
OFF
MAX
PHONES
TALKBACK
U
+60dB
20
30
40
UTILITY