NautiCharger PM-0600H User Manual - Warning !
-7-
G. Quick hook – up and testing:
If you would like to quick hook-up the power inverter and check its
performance before going ahead with your installation, please follow
these guidelines:
G-1. Unpack and inspect the power inverter, check to see that the
power switch in the OFF position.
G-2. Connect the DC NEGATIVE cable to the Negative (NEG-)
terminal on the battery next, connect the cable to the negative
terminal on the inverter.
The connection to the negative terminal off the Inverter should
be the last connection made. A spark when making this final
connection is normal.
G-3. Before proceeding further, carefully check that cable you have
just connects from the negative terminal of inverter to the
gative output terminal of power source.
G-4. Connect the cable from the positive terminal of inverter to the
positive terminal of the power source. Make secure connection.
WARNING !
You may observe a spark when you make this connection since
current may flow to charge capacitors in the power inverter.
. Do not make this connection in the presence of
flammable fumes, explosion or fire may result.
WARNING!
Make sure all the DC connections are tight (torque to
9-10 ft-lbs,11.7-13Nm). Loose connections will
overheat and could result in a potential hazard.
CAUTION!
Reverse polarity connection will blow a fuse in Inverter and may
permanently damagethe inverter.
Damage caused by reverse polarity connection is not
covered by our warranty.
¡ Ï
¡ Ð