NovaTec S3 Installation Manual - page 18
Subject to change
Page 18 of 26
Version 2.2 / Date: Sept 2013
NovaTec Kommunikationstechnik GmbH
E-Mail:
info@novatec.de
Phone: +49 (0)5251 1589-610
Technologiepark 9 / DE-33100 Paderborn
Internet:
www.novatec.de
Telefax: +49 (0)5251 1589-611
7.2 How to upload the firmware license into the configuration
1. Select the menu topic „Licensing/FW-License“.
2. Select the license sent to you by NovaTec for the related target system(s).
3. Prepare the configuration.
4. Transfer the configuration onto the target system.
You will receive the license from NovaTec via mail (please be aware of the details under 6.2).
7.3 Preparation and transfer of the data
Before transferring the data these have to be prepared. The preparation is carried out with the “Process”
function in the pull-down menu (picture 11) or by pressing the “F7” key.
Picture 11
During this process a basic plausibility check of the configuration is carried out. Without the successful
execution of the preparation the data cannot be transferred onto the target system. If the plausibility
check detects errors in the configuration an adequate message with a failure indication will pop up. After a
successful preparation of the data these can be transferred to the target system with the function “Trans-
mit to target system” or by pressing the “F5” key. You will find a button “Extras/Save Config.” within the
configuration mask. We recommend the usage of this button whereby the configuration data will not only
be saved on the target system as packed file but also in their original form. Even though the transmission
time is prolonged with this choice it is important when logging into the S3 system from a remote PC that