NovaTec S3 Installation Manual - page 3
Subject to change
Page 3 of 26
Version 2.2 / Date: Sept 2013
NovaTec Kommunikationstechnik GmbH
E-Mail:
info@novatec.de
Phone: +49 (0)5251 1589-610
Technologiepark 9 / DE-33100 Paderborn
Internet:
www.novatec.de
Telefax: +49 (0)5251 1589-611
1
Introduction
Dear Customer
We congratulate you on purchasing the NovaTec S3 . You have decided on buying a Gateway which was
developed and produced utilizing the newest technical standards. The S3 is available in several versions
and depending on the version provides the following interfaces (details see diagram in chapter 4.1):
-
IP (SIP protocol),
-
S
0
(each NT/TE configurable),
-
U
p0
(each NT /TE configurable, only point-to-point) and
-
analogue a/b.
This installation manual describes the installation and the initial operation of the S3. You are advised to
read the entire manual thoroughly before starting the installation step by step.
2
Security Advice
-
Do not install the S3 near to heaters or heating appliances and sources of electrical interferences such
as fluorescent lamps and electric motors.
-
Protect the S3 from dust, moisture, shock and vibration as well as from direct sunshine.
-
Make sure that no foreign material like wire, cable ends, nails or small metal parts fall into the open-
ings on the upper surface of the unit.
-
The S3 cannot be used before the installation has been duly executed.
-
Never use petrochemicals to clean the housing. For cleaning purposes, use a soft and dry cloth only.
-
In case that an internal component is obviously damaged, e.g. because of a damaged housing, please
remove the S3 from the power supply immediately.
-
In order to avoid material damage or injury to persons, never expose the S3 to water (rain) or exces-
sive moisture.
-
For safety reasons it is not allowed to alter the S3 construction- or safety-related without prior explicit
approval from NovaTec Kommunikationstechnik GmbH.
-
NovaTec Kommunikationstechnik GmbH is not liable for damages resulting from any alterations. In
particular repairs of all nature and any soldering on the PCB’s are forbidden.
-
The installation manual must always be delivered with the equipment when given to a third party.